Hamilton Spectrograph
This section contains descriptions of the electronics version 2 of the Hamilton Spectrograph.
Schematic: schematics/HAM_II_block_sh_1.pdf
Page last updated: June 22, 2010
Fig. 1 Simplified Drawing Sheet 1
Schematic: schematics/HAM_II_block_sh_2.pdf
Fig. 2 Simplified Drawing Sheet 2
Schematic: schematics/HAM_II_block_sh_3.pdf
Fig. 3 Simplified Drawing Sheet 3
Fig. 4 Simplified Drawing Sheet 4
Sheet 4 of the schematic simply illistrates the correct placement of jumpers for our situation. Though the actual schematic shows both the DMC-4080 and the DMC-4040, the jumper settings for the DMC-4040 are exactly the same as the DMC-4080 less the second amplifier enable block. For the Hamilton we have set AECOM1 to +5v and AECOM2 to GND. The block in the lower left cornor show a jumper in the MO position. This is the Motor Off on power up jumper.