TV Testing
C.
Harper 12-12-01
1.
Remove
covers from the camera, pick off mirror and the tilt mirror.
2.
Power
up sequence from kics @celeste:
% modify –s deimot tvcampow = on (takes ~ 30 sec to run diagnostics)
% modify –s deimot tva2spow = on
% modify –s deimot tvs2fpow = on
3.
Bring
up kcamtest program from harper @Shoppe:
% camera
If driver error or camera not open error messages
come up, then from
harper @shoppe %super reload-driver
4. For set up choose:
-camera,
then open and pvcam2
-camera,
then status. Displays CCD temp. It
will take 20 minutes to get to -15°C.
-exposure,
then setup. Enter 25 ms exposure
time.
4.
Turn
on lamp.
5.
Check
filter position (clear =5) and focus position (+960 best focus).
6.
To take an exposure:
-exposure,
then single
or ^E
5.
Save
an image:
-file,
then save as. Enter the file name
with .fits
i.e. /u/harper/filename.fits
or ^A
6.
Exit
kcamtest before powering down the system.
-file,
then quit
7.
Power
down sequence from kics @celeste:
% modify –s deimot tvs2fpow = off
% modify –s deimot tva2spow = off
% modify –s deimot tvcampow = off
8.
Replace
the three covers.
\\LOELHOST\C_Loelhost\My
Documents\DEIMOS_Docs\TV Stage\TV Testing.doc